Zytronic Projected Capacitive X-Y controller Touchscreen Manual de usuario descargar pdf (Pagina 16)

Draft copy

Do not use!!

SAFE OPERATING PROCEDURE

Touchscreen Driver Software Procedure

Subject

19” Touchscreen Driver Software Procedure

Name and

number of

UPGRADE

Page

16 of

• Unplug USB.cable

• Then re-add Software by

clicking Add/Remove.

• Plug in USB cable.

• Test Screen.

____4.3 Launching the Test Sensor page

displays the x and y sensor wire

array matrix levels.

Applying a touch to the sensor will

wires levels. This graph can be

used to determine the correct

operation of all the wires within the

sensor. This can be done by

applying a touch to the sensor and

moving your finger left to right then

top to bottom over the sensor. All

wires should register a peak

relative to your finger movement

across the sensor, as shown in

Figure 1-12.

NOTE: Touch operation is disabled when the Test Sensor page is open. The Test

Sensor page can be terminated by using the Escape key via a connected

keyboard or using a mouse to press the Close button located in the bottom right

hand corner of the page.

____4.4

• If any of the x and y wire

levels do not move when a

touch is applied and moved

left and right, top and bottom

across the screen. (Section

4.3 and associated NOTE).

The Software and

touchscreen USB should be

removed. The software

should be reinstalled and the

1 2 ... 11 12 13 14 15 16 17 18 19 20 21

Draft copy 1
Do not use!! 1

Comentarios a estos manuales

Sin comentarios

Zytronic Projected Capacitive X-Y controller Touchscreen Manual de usuario Pagina 16

Comentarios a estos manuales

Relacionado con productos y manuales para Televisores y monitores Zytronic Projected Capacitive X-Y controller Touchscreen